Rolling bearing bearing equipment and sub-parts

March 24, 2019

Home>Bearing knowledge>Rolling bearing equipment and sub-components
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Rolling bearing bearing equipment and sub-parts

Source: China Bearing Network Time: 2013-03-19

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
1. Paired device pairedmounting
The two sets of tumbling bearing ends face a device on the same axis as the end face; it can be regarded as a whole when working. The bearing can be back-to-back, face-to-face or in series.
2. Combination unit stackmounting
Three or more sets of rolling bearing ends face a device on the same axis as the end face; it can be regarded as a whole when working.
3. Back-to-bacdarrangement
Two sets of rolling bearings adjacent to the outer ring of the opposite side of the device approach.
4. Face-to-facearrangement
Two sets of tumbling bearings adjacent to the outer ring front facing the front of the device approach.
5. Tandem equipment
The set of bearing outer ring of two or more sets of rolling bearings is opposite to the front of the outer ring of the next set of bearings.
6. Paired matchpair
Two sets of rolling bearings selected or made according to a predetermined characteristic (generally according to preload or clearance); and installed together according to the rules.
7. Matching matched stack
Three or more sets of rolling bearings are rated according to their characteristics; generally selected or produced according to preload or clearance; and installed together according to the rules.
(two) sub-components
1. Sub-unit
A bearing ring or bearing washer with a cage or rollover that can be freely removed from the bearing; a roll and cage assembly that can be freely removed from the bearing.
2. Interchangeable sub-unit
A sub-assembly can be exchanged by other sub-components of the same group without affecting the function of the bearing.
3. Inner ring, cage and ball (roller) assembly innerringcageandball(roller)assembly
a sub-assembly consisting of an inner ring, a ball (roller) and a cage.
4. Conical inner ring assembly coneassembly
a sub-assembly consisting of a conical inner ring, a tapered roller and a cage.
5. Outer ring, cage and ball (roller) assembly outerringcageandball(roller)assembly
a sub-assembly consisting of an outer ring, a ball (roller) and a cage.
6. Needle roller bearing without inner ring needlerollerbearingwithoutinnerring
A sub-assembly consisting of an outer ring and a full-loaded needle or an outer ring and a needle and cage. When required, the bearing replenishment can be added to this section; for example: "needle bearing; full ; stamped outer ring; no inner ring "or" needle roller bearing has cage; mechanism ferrule; no inner ring".

Recommend to friends comments close window

Bearing related knowledge
New skills and development direction of bearing steel (1)
Analysis of the vibration and noise reduction skills of the ball bearing and the heat treatment skills of the bearing of the process equipment. Analysis of the demand and the fundamental function of the bearing steel.


This article links to http://
Please indicate the bearing network http://

Previous:The difference between cylindrical roller bearings N, NU, NF, NJ is discussed in detail. The following is a description of the SKF stamping bracket.

Traditional Basin Faucet

Wash Hand Basin Tap,Magic Water Faucet,Wash Basin Mixer Tap,Sanitary Basin Faucet

Wenzhou Yili Sanitary Ware Co., Ltd. , http://www.cn-faucet.com