Tile paving tips seven strokes to help you complete the perfect

September 27, 2019

Tiles are an essential decoration material for our bathroom renovations, mainly used on walls and floors. In the bathroom decoration, we must first ensure that the quality of the tiles purchased is good or bad, and it is also very important to ensure the tile laying process. The quality of tile paving directly affects the success or failure of bathroom decoration. So how do you lay out the bathroom tiles? What are the techniques for bathroom tile laying? Let's learn about the tile-laying skills with Xiaobian, and seven tips to help you finish perfectly.

Ground tiling construction skills

1. If the ceramic floor tiles are used for tiling, the ceramic floor tiles should be immersed in the shade.

2. When tiling, the cement mortar should be satisfactorily applied to the back of the ceramic floor tile, and then spliced ​​with a rubber plaque. At the same time, check the calibration with a level gauge and wipe the surface cement mortar.

3. After the tile is finished for 2 to 3 hours, use white cement to grind the seam. Use cement, sand = 1:1 (volume ratio) cement mortar, and the seam should be densely packed and smooth. Wipe the surface with cotton wool.

Construction techniques for wall tile paste

1. When the base layer is treated, all kinds of dirt on the wall surface should be cleaned and watered and moistened one day in advance. If the base layer is a new wall, when the cement mortar is 70% dry, it should be arranged for brick, bullet and paste.

2. The standard point must be pasted before the official paste to control the flatness of the pasted surface. The flatness should be checked by the ruler at any time during operation. If it is uneven or not straight, it should be removed.

3. Before the tile is pasted, it must be soaked in clean water for more than two hours. Take the brick body without bubbling, take it out and dry it for use. Paste from the bottom to the top when pasting, requires the mortar to be full, when the ash is lost, it must be removed from the sticky, and it is not allowed to fill the ash from the brick joint or the mouth.

4. When encountering the pipeline, the switch of the lamp, the support of the bathroom equipment, etc., it must be cut and matched with the whole brick set, and it is forbidden to use the non-whole brick to piece together. The whole or separate parts should be pasted one at a time. When the one time cannot be completed, the joints should be left at the construction joint or the corner of the corner.

Nonionic surfactant made from natural fatty alcohols and glucose derived from renewable plants.  Superior detergency, wetting and surface active ability. High solubility in concentrated alkaline solutions and other electrolytes and will solubilize other less soluble ingredients. Good compatibility with all other types of surfactants and synergistic effects can be found. It can improve the mildness of formulations significantly. Produces rich and stable foam. non-toxic, non-irritating to skin, readily biodegradable.


Alkyl Polyglucoside

Alkyl Polyglucoside,Alkyl Polyglycoside,Apg Alkyl Polyglucosides,Lauryl Glucoside

NINGBO LUCKY CHEMICAL INDUSTRY CO. LTD , https://www.chinaluckychem.com